English
Cable Tracing
A successful cable fault location relies on knowing the position of the cable and other lines laid in the soil.
Magnetic frequency procedures can be used to establish the position and depth of the cable using the minimum or maximum method.
The exact position of a joint can be established using the Twist Field Method.
Products
Cable Sheath Fault Location
The cable sheath is usually insulated with PVC or PE synthetic, in order to prevent ingress into the insulation. To detect faults at the earliest possible stage, DC sources are used to test sheath insulation and DC impulse signals for locating sheath faults.
Products
Cable Identification
Reliable readout is a safety-specific activity prior to cutting a cable. The computer-supported APT (Amplitude – Phase – Time) procedure developed by BAUR is the most reliable method of reading out one core the other.
Produkte
Twist Field Location
The Twist Field Location Method patented by BAUR is successfully employed in signal and multi-core cable installations. If conventional location of saturated short circuits fails in locating sleeves, the magne¬tic frequency twist field location method provides a simple solution.
Products
Voltage Drop Method
Voltmetric methods are used to locate the sheath fault and establish faults on illumination cables or low-voltage cable installations from the voltage drop.
Products
Acoustic Fault Location
The acoustic method is applied for precise pin-pointing of the cable fault. The filter that can be selected in the receiver and the propagation time measurement supports the user in field applications and permits a reliable, precise location of the fault even in difficult soil conditions.
Products
Decay Method and Differential Decay Method
The Decay Methods are used to locate cable faults with high break down voltage > 32 kV. A VLF or DC high-voltage source ignites the high-resistance fault and the transient wave recorded in the echometer is used to measure the fault distance.
Products
Surge Current Differential Method DICM
The simultaneous measurement of two cable cores using the differential method enables the fault distance to be determined, even with cable faults that are difficult to locate. This measuring method is applied particularly for long cables, e.g. >10 km, in the T-branch network and overhead transmission line faults.
Products
Impulse Current Method ICM
ICM is the conventional location method for high-resistance cable faults, especially on long cables.
A surge voltage generator up to 32 kV is coupled to an echometer via a current converter. The breakdown in the fault generates a current impulse, which is recorded by the echometer.
Produkte
Secondary Impulse Method SIM Multiple Impulse Method MIM
The SIM/MIM is the latest and most efficient measuring method for pre-locating cable faults. The particular benefits of this method is the simple handling, universal application and extremely simple interpretation of the echograms.
High-resistance faults are ignited by a surge voltage impulse, the fault distance is measured repeatedly by the IRG Echometer within a single discharge, automatically stored and displayed on the screen. The fault distance evaluation runs fully-automatically.
Products
Fault Burn Down Technology
High-resistance cable faults are treated using powerful high-voltage burner units. The emerging fault is low-resistance and can therefore easily be measured using the TDR method. This application is employed for conventional PILC cables.
Products
